KSANT-12356-B
KEESUN
KSANT-12356-B
| Availability: | |
|---|---|
| Quantity: | |
An L-band satellite path has to be received with the right polarization, and a linear antenna on a circular signal loses half the power before the cable even starts. The 1520–1560 MHz range is used for satellite L-band downlinks, and the demand for a panel that holds 17 dBi in a flat body has never been higher. Site operators are constantly challenged to mount a high-gain receive antenna on a wall or a short mast without a dish. The solution lies in a circularly polarized panel with a narrow beam. We are proud to introduce the 1520–1560 MHz 17 dBi LHCP Directional Panel Antenna, model KSANT-12356-B, a 600×600×33 mm white ABS panel with one N-female port.
This part answers a circular-polarization receive requirement. The band is 1520–1560 MHz, 40 MHz wide, and the gain is 17 dBi. Polarization is left-hand circular, which is what a circular signal needs if the antenna is not to throw away 3 dB at the feed. The horizontal beamwidth is 29–41° and the vertical beamwidth is 16–19°, so the beam is narrow in elevation and moderate in azimuth. Front-to-back ratio is 24–31 dB. The port is 50 Ohm, VSWR <2.0 and 50 W, terminated in a single N-female connector. The body is 600×600×33 mm white ABS, it weighs 7.56 kg, wind rating is 36.9 m/s, the range is −45 °C to +85 °C, and the element is DC grounded. The datasheet photos show the tilt bracket and U-clamps that ship with it.
The panel's value rests on three points: 17 dBi from a 600 mm square, left-hand circular polarization, and a single port in a thin body.
The aperture is 600×600 mm and the gain is 17 dBi on 1520–1560 MHz. At 1.54 GHz that aperture is large in wavelengths, so the panel delivers 17 dBi without a dish or a feed horn. That matters for a receive site: 17 dBi buys link margin on a weak satellite downlink, and it does it from a flat body that mounts on a wall. The horizontal beamwidth is 29–41° and the vertical is 16–19°, which is tight enough to keep the beam off the ground clutter and wide enough to allow for mount tolerance.
The polarization is left-hand circular. A circular signal arrives rotating, so a linear antenna picks up only one component and loses about 3 dB against a circular antenna. This panel matches the rotation instead of fighting it. The front-to-back ratio of 24–31 dB keeps the energy on the satellite path and off the building behind the mount. For a receive site where the signal is already weak, that 3 dB is the difference between a usable link and a link that drops in rain.
The panel is 600×600×33 mm, only 33 mm thick, with one N-female port. A single port keeps the install simple: one cable, one connector, one ground point. The radome is white ABS, which is light and needs no paint outdoors, and the unit weighs 7.56 kg. The wind rating is 36.9 m/s, the element is DC grounded, and the range is −45 °C to +85 °C with humidity under 95%. Qualification is written out: a 1 m drop test, a ≥20 N pull force test, vibration from 10–55 Hz at 0.35 mm and 50.0 m/s² over 30 cycles, and 1.5 kV insulation, 1.5 kV sheath and 0.5 kV insulation-to-sheath withstand. The part is RoHS compatible.
Seventeen dBi, left-hand circular polarization and a narrow elevation beam make this panel useful wherever a circular L-band signal has to be received.
L-band downlink reception: 17 dBi and LHCP match a circular downlink, and the narrow elevation beam keeps the path clear of ground noise.
Fixed satellite terminals: a flat panel mounts on a wall or a short mast, which suits a site that cannot carry a dish.
Telemetry receive sites: the 40 MHz band covers the channel plan, and the 24–31 dB front-to-back ratio rejects the site behind the antenna.
Small ground stations: one panel and one N-female cable run give a compact receive front end for a remote terminal.
Satellite monitoring: circular polarization lets a monitoring site receive a circular signal without a polarization rotator.
Antenna test ranges: a 600 mm square aperture with known beamwidth is a stable reference for circular-polarization and link-budget work.
The 1520–1560 MHz 17 dBi LHCP Directional Panel Antenna, KSANT-12356-B, does one job: it receives a circular L-band signal with gain and without a dish. The 600×600×33 mm white ABS panel covers 1520–1560 MHz at 17 dBi with left-hand circular polarization, a 29–41° horizontal and 16–19° vertical beam, and 24–31 dB front-to-back ratio. The port is 50 Ohm, VSWR <2.0 and 50 W behind one N-female connector, the unit weighs 7.56 kg, and the wind rating is 36.9 m/s. For a circular L-band receive site that needs reach in a flat body, this panel is the part that does the work.