Where these components are used
Different industries ask different things of the same RF link. What they share is a need for an antenna and feed line that hold their performance in the field.
Surveying and machine control
A fixed RTK solution depends on a GNSS antenna with a clean radiation pattern and stable phase centre. Keesun's GNSS antennas and low-loss cable assemblies help rovers and machine-control receivers hold a fix as they move across a site.
Precision agriculture
Auto-steer and guidance systems need continuous satellite reception across open fields. GNSS antennas with right-hand circular polarisation and wide beamwidth keep the signal steady as the vehicle tilts and turns.
Timing and synchronization
Substations, base stations and data networks take time from GNSS. A dedicated timing antenna with a clear sky view, fed through a low-loss coaxial link, keeps distributed systems in step.
UAV and telemetry
Drones and telemetry links combine GNSS with a data radio. Compact GNSS antennas and MIMO antennas from one supplier simplify the RF stack and reduce integration work.
The problems on the ground
Most RF problems are not dramatic failures. They are small, persistent losses that get baked into a system before anyone notices.
- Weak or unstable satellite signal. An antenna with poor gain or the wrong polarisation loses fix near structures and under canopy, and the positioning solution degrades.
- Losses in the RF path. Long or lossy coaxial runs eat into an already-small GNSS signal, especially at 1575.42 MHz, weakening accuracy at the receiver.
- Mismatch between parts. An antenna, connector and cable chosen from different vendors can mismatch in impedance or VSWR, adding reflections and measurement error.
- Outdoor exposure. Dust, moisture and wide temperature ranges take out components that were never rated for a field installation.
- No help with custom layouts. When the mounting position or cable length is non-standard, off-the-shelf parts do not fit and there is no one to design a version that does.
What KEESUN delivers
We design the antenna, the cable and the connector as one matched chain, so performance survives the move from the datasheet to the installation.
Technical capabilities at a glance
| Capability | Detail |
|---|---|
| GNSS antenna | 1575.42 +/- 5 MHz, 3 dBi, RHCP, VSWR <= 2.0 (typical passive model) |
| Environmental | IP65, -40 to +55 degrees C, FRP radome (typical outdoor model) |
| Impedance | 50 ohm across antennas, connectors and cable assemblies |
| Connectors | SMA, TNC, N, BNC, MCX, MMCX, SMP and precision types to 110 GHz |
| Custom service | OEM/ODM, cable length, mounting configuration, RF test reports |
| Quality | ISO 9001:2015, ISO 14001:2015, 100% RF inspection |
Note: figures shown are typical values from Keesun product documentation and vary by model. Keesun supplies antennas and RF interconnect components; system-level positioning, communication and tracking performance depends on the complete design.
Next step. Tell us your frequency band, gain target, mounting position and cable length. We will propose an antenna and RF interconnect setup and share test data.
Talk to an engineer