Frequency Range: 1300–1550 MHz (Port 1 and Port 2)
Gain: 15–16.5 dBi (Port 1), 15–17 dBi (Port 2), 16 dBi nominal
V.S.W.R: <2.0
Nominal Impedance: 50 Ohm
Polarization: Vertical (both ports)
Maximum Power: 50 W (per port)
KSANT-12356-A
KEESUN
KSANT-12356-A
| Availability: | |
|---|---|
| Quantity: | |
An L-band link has to cross a long distance with a small antenna, and the only way to do it is to squeeze the beam. The 1300–1550 MHz range is used by narrowband links, telemetry and private networks, and the demand for a panel that holds 16 dBi in a flat body has never been higher. Site planners are constantly challenged to fit a high-gain antenna onto a wall or a short mast without a dish. The solution lies in a panel with a narrow beam and a square aperture. We are proud to introduce the 1300–1550 MHz 16 dBi High-Gain Directional Panel Antenna, model KSANT-12356-A, a 600×600×33 mm white ABS panel with two N-female ports.
This part answers a long-reach L-band requirement. The band is 1300–1550 MHz, which is 250 MHz wide, and the panel covers it on both ports. Port 1 gives 15–16.5 dBi and Port 2 gives 15–17 dBi, so the nominal figure is 16 dBi. The horizontal beamwidth is 29–41° and the vertical beamwidth is 15–19°, which is a narrow elevation beam. Front-to-back ratio is 24–31 dB on Port 1 and 23–29 dB on Port 2. Both ports are vertical polarization, 50 Ohm, VSWR <2.0 and 50 W. The body is 600×600×33 mm white ABS, it weighs 7.56 kg, the wind rating is 36.9 m/s, the range is −45 °C to +85 °C, and the element is DC grounded. The datasheet photos show the tilt bracket and U-clamps that ship with it.
The panel's performance rests on three points: 16 dBi from a 600 mm square, a beam narrow enough for a long link, and a 33 mm body that mounts flat on a wall.
The aperture is 600×600 mm and the gain is 15–17 dBi across 1300–1550 MHz. At 1.4 GHz that aperture is about 1.2 m², which is enough to reach 16 dBi without a dish. A square panel gives the same aperture in both planes, so the beam stays symmetric enough to aim at a fixed point. For a link that has to clear a valley or a town, 16 dBi buys margin that an omni cannot.
The horizontal beamwidth is 29–41° and the vertical is 15–19°, so the beam is narrow in elevation and moderate in azimuth. That shape suits a long path: the narrow vertical beam keeps the energy off the ground and off nearby roofs, and the horizontal width leaves room for mounting tolerance. The front-to-back ratio of 24–31 dB on Port 1 and 23–29 dB on Port 2 means the panel does not waste power behind the mast. The measured sweep in the datasheet shows VSWR between 1.39 and 1.64 across the band, which is below the specified 2.0.
The panel is 600×600×33 mm, only 33 mm thick, and it carries two N-female ports. Two ports on one body let a site feed two radios or two branches from one mount without a second antenna and a second set of brackets. Each port takes 50 W. The radome is white ABS, which is light and does not need paint outdoors, and the unit weighs 7.56 kg. The wind rating is 36.9 m/s, the element is DC grounded, and the operating range is −45 °C to +85 °C with humidity under 95%. Qualification is written out: a 1 m drop test, a ≥20 N pull force test, vibration from 10–55 Hz at 0.35 mm and 50.0 m/s² over 30 cycles, and 1.5 kV insulation, 1.5 kV sheath and 0.5 kV insulation-to-sheath withstand. The part is RoHS compatible.
Sixteen dBi, a narrow elevation beam and two ports make this panel useful wherever an L-band link has to cover distance.
Long L-band backhaul: 16 dBi and a 15–19° vertical beam carry a link across a valley, a river or a rural path from a short mast.
Fixed wireless links: the 29–41° horizontal beam aims at a specific site, and the 24–31 dB front-to-back ratio keeps the rear clean.
Utility and pipeline telemetry: the 250 MHz band covers several channels in one panel, and the narrow beam reaches a remote terminal.
Private and tactical networks: two N-female ports feed two radios from one mount, which keeps a small site simple.
RF monitoring: the narrow elevation beam and high front-to-back ratio let a receiver look at one direction on 1300–1550 MHz.
Antenna test ranges: a 600 mm square aperture with known beamwidth is a stable reference for pattern and link-budget work.
The 1300–1550 MHz 16 dBi High-Gain Directional Panel Antenna, KSANT-12356-A, does one job: it puts 16 dBi on a flat body. The 600×600×33 mm white ABS panel covers 1300–1550 MHz on two N-female ports, gives 15–17 dBi with a 29–41° horizontal and 15–19° vertical beam, and holds 24–31 dB front-to-back ratio. Both ports are vertical polarization, 50 Ohm, VSWR <2.0 and 50 W, the unit weighs 7.56 kg, and the wind rating is 36.9 m/s. For an L-band link that needs reach without a dish, this panel is the part that does the work.