Frequency Range: 200–300 MHz, 300–8500 MHz
Gain: −4~1 dBi (200–300 MHz), −1~7 dBi (300–8500 MHz)
V.S.W.R: <9.0 (200–300 MHz), <2.5 (300–8500 MHz)
Nominal Impedance: 50 Ohm
Polarization: Linear
Maximum Power: 100 W
KSANT-12403-A
KEESUN
KSANT-12403-A
| Availability: | |
|---|---|
| Quantity: | |
A test range or a monitoring site usually has to cover a decade of spectrum, and a decade of spectrum means either a rack of antennas or one very wideband radiator. Buying and calibrating a dozen antennas is slow and costly, and switching between them during a scan wastes time. The demand for one antenna that spans 200 MHz to 8.5 GHz has never been higher. The solution lies in a dual copper cup radiator that needs no radome and no tuning per band. We are proud to introduce the 200–8500 MHz Ultra-Wideband Dual Copper Cup Omni Antenna, model KSANT-12403-A, a φ150×310 mm bare-copper biconical radiator with a 30 cm SMA-male pigtail.
This part answers a full-spectrum requirement in one body. It covers 200–300 MHz and 300–8500 MHz with 360° azimuth coverage. Gain is −4~1 dBi on the low band and −1~7 dBi above 300 MHz. VSWR is <9.0 on the low band and <2.5 from 300 MHz to 8.5 GHz. Efficiency is about 50% on the low band and about 60% above 300 MHz. Polarization is linear, impedance is 50 Ohm, and maximum power is 100 W. The vertical beamwidth is 40–55° on the low band and 6–130° across the rest. The body is two copper cups back to back with no outer jacket, it weighs 0.52 kg, the feed is a 30 cm RG303 cable with an SMA-male plug, and the range is −45 °C to +85 °C with DC grounding.
The antenna works on three points: a bandwidth that runs from 200 MHz to 8.5 GHz, a bare copper cup build with no radome loss, and a round azimuth pattern that holds across the sweep.
The sweep runs 200 MHz, 300, 500, 2.5 GHz, 3.8, 4.5, 5.5, 6.5 and 8.5 GHz in one antenna, and the measured VSWR stays under 2.5 from 300 MHz up. That is a bandwidth ratio of about 28:1 above the low band. For a monitoring rack or a test range, one antenna replaces a shelf of band-specific models, and every scan uses the same calibration.
The radiator is two copper cups joined back to back, and there is no fibreglass or plastic radome over them. That is deliberate: every radome adds loss and adds a dielectric that shifts the pattern, and on a wideband antenna those effects grow with frequency. Bare copper keeps the aperture clean and the loss low. The body is φ150×310 mm and weighs 0.52 kg, so one person can move it between test positions by hand. Copper is also stable outdoors: it does not need paint, and the element is DC grounded.
Horizontal beamwidth is 360° on both bands, so the pattern stays round as the antenna is rotated. Out-of-roundness is ±3 dB on the low band and ±2.5 dB above 300 MHz, which is tight for a radiator this wide. The measured VSWR is 1.38 at 300 MHz, 1.48 at 2.5 GHz, 1.36 at 4.5 GHz, 1.61 at 5.5 GHz and 2.12 at 8.5 GHz. Peak measured gain reaches 7.0 dBi at 4 GHz and sits between −1 and 3.9 dBi across most of the upper band. The low band is the honest limit: at 200 MHz the measured VSWR is 8.48 against a 9.0 limit, and efficiency is 33.8%, because a φ150 mm body is small in wavelengths at that frequency. The feed is a 30 cm RG303 cable with an SMA-male plug, power handling is 100 W, and the wind rating is 36.9 m/s. The part is RoHS compatible.
A 28:1 bandwidth, a round pattern and 100 W make this antenna useful wherever one radiator has to cover a decade of spectrum.
EMC pre-compliance: one antenna covers 200 MHz to 8.5 GHz, so a radiated-emission sweep runs without changing the antenna mid-scan.
Antenna and site test beds: the round pattern and known out-of-roundness make it a stable reference for comparison and link-budget work.
Spectrum monitoring: 360° azimuth and a low VSWR above 300 MHz let one receiver watch a decade of spectrum from one spot.
Site survey and interference hunting: the φ150×310 mm body and 0.52 kg weight let one person carry the antenna between locations.
Multi-service sites: one radiator covers land-mobile, WiFi, 5G and 6 GHz links, which keeps a mast clear for the radios that matter.
Drone and RF detection work: the wide band and round pattern catch emitters across several services without band switching.
The 200–8500 MHz Ultra-Wideband Dual Copper Cup Omni Antenna, KSANT-12403-A, answers one problem: a decade of spectrum and one antenna. Two bare copper cups on a φ150×310 mm body cover 200–300 MHz and 300–8500 MHz with 360° azimuth, gain from −4~1 dBi on the low band to −1~7 dBi above 300 MHz, VSWR <9.0 on the low band and <2.5 above 300 MHz, and 100 W. The 0.52 kg weight, 30 cm RG303 pigtail with an SMA-male plug, DC grounding and −45 °C to +85 °C range state its limits up front. For a test range or a monitoring site that has to sweep a decade, this cup antenna is the part that covers it.