1500–1600 MHz 5 dBi Glossy Black Fiberglass Omni Antenna, Integrated N-Male, IP67, KSANT-12344-A

The 1.5 GHz block is where an increasing amount of private mobile, telemetry and low-band broadband traffic lands, and the demand for antennas that survive outdoors in every direction has never been higher. Network planners are constantly challenged to cover a parking lot, a depot or a coastline from one pole, on a band where users move in every direction and the rain, salt and UV are harder on the hardware than the link budget. The solution lies in sealed fiberglass omni antennas that put a round pattern on the horizon and keep water out for years. We are proud to introduce the 1500–1600 MHz 5 dBi Glossy Black Fiberglass Omni Antenna, model KSANT-12344-A, a 600 mm linear-polarized radiator engineered for outdoor 1.5 GHz private networks, telemetry and wide-area coverage.

This antenna represents a practical balance between pattern roundness, finish and ingress protection. Its core advantage is the format: a single 600 mm radome at 20 mm diameter, weighing 0.23 kg, finished in glossy black, terminated in an integrated N-male connector and sealed to IP67. The band is covered from 1500 to 1600 MHz at 50 Ohm with VSWR <2.0, peak gain runs 4.5–5.5 dBi, and the horizontal pattern is a full 360° with out-of-roundness held to ±1 dB. Power handling is 100 W, the element is DC grounded, and the radome is rated for wind of 36.9 m/s across an operating range of −45 °C to +85 °C. It is the practical choice where one slim antenna has to cover everything that can see the pole.

Technical Excellence: The Core Advantage

The antenna's performance rests on three pillars: a round horizontal pattern, a wider vertical beam suited to low-mast sites, and an IP67 sealed build for outdoor life.

360° Coverage with ±1 dB Roundness

An omni antenna is only as good as its roundness, and this design specifies it at ±1 dB. The chamber report backs that up: measured out-of-roundness is 0.42 dB at 1500 MHz, 0.34 dB at 1550 MHz and 0.35 dB at 1600 MHz. In practice that means a user on the north side of the site gets substantially the same signal as one on the east, so capacity planning does not absorb a pattern that quietly favours one direction. Because there is no preferred azimuth, the antenna can be mounted without a compass bearing: there is nothing to line up.

4.5–5.5 dBi with a 21–26° Vertical Beam

Peak gain is specified at 4.5–5.5 dBi, and the chamber measurements track it closely: 4.8–5.4 dBi from 1500 to 1600 MHz, with efficiency between 73.8% and 80.8%. The vertical beamwidth is 21–26°, deliberately wider than a high-gain collinear. That is the right trade for short masts, parking lots and warehouses: the energy spreads far enough vertically to cover users close to the mast instead of concentrating on the horizon and leaving the site at the foot of the pole weak. The radome is 20 mm in diameter and 0.23 kg, so it can be carried up a ladder by one person and mounted on a wall bracket or a light pole.

IP67 Sealed, 100 W and an Integrated N-Male Connector

The datasheet carries a dedicated IP67 test report, which is the honest statement for an outdoor product rather than a promise of "weather resistance". The specified match is VSWR <2.0 across 1500–1600 MHz, and the stored trace marks 1.26 at 1500 MHz and 1.41 at 1600 MHz, with return loss of 18.9 dB and 15.3 dB at those two points. Maximum power is 100 W, which covers a small-cell or private mobile transmitter with headroom for multi-carrier operation. The connector is integrated into the base rather than fitted as an adapter, which removes one mechanical joint and one source of water entry, and it is an N-male type that screws directly onto the feeder. The radiating element is DC grounded, so static charge built up by wind and precipitation drains to the mast instead of down the coax. Mechanical qualification is stated rather than assumed: a ≥200 N pull force test, a 1 m drop test, vibration from 10–55 Hz at 0.35 mm displacement and 50.0 m/s² over 30 sweep cycles, and voltage resistance of 1.5 kV insulation, 1.5 kV sheath and 0.5 kV insulation-to-sheath. The product is RoHS compliant.

Versatile Application Scenarios

The combination of a round pattern, 5 dBi and IP67 sealing makes this antenna useful wherever a single pole has to serve outdoor users in every direction.

1.5 GHz Private Mobile and LTE

Private LTE and private mobile networks: one omni covers a depot, a port or a logistics yard without sector overlap, which is what a single-carrier 1.5 GHz site needs.

Fleet and dispatch radio: vehicles and handhelds move around the site at every bearing, and a round pattern keeps the link steady from gate to loading bay.

Outdoor Industrial and Coastal Sites

Parks, yards and coastal infrastructure: the IP67 seal means rain, salt spray and wash-downs do not end the antenna's life, and the glossy black finish keeps it visually quiet on light poles.

Building rooftops and street furniture: the 0.23 kg weight and 600 mm length allow mounts on parapets and façades where a panel would look intrusive.

Telemetry and Low-Power Backhaul

SCADA and remote telemetry: substation, pipeline and sensor links need steady omnidirectional coverage over years, and the −45 °C to +85 °C range covers unattended outdoor cabinets.

Temporary and event sites: the integrated N-male connector and light weight make the antenna quick to deploy and recover, which suits pop-up networks, construction sites and broadcast support.

Conclusion: The Future of Slim Outdoor Omni Coverage

The 1500–1600 MHz 5 dBi Glossy Black Fiberglass Omni Antenna, KSANT-12344-A, is more than a passive component. It is the part that decides whether a 1.5 GHz site covers a yard or one corner of it. By holding out-of-roundness to ±1 dB across a full 360°, covering 1500–1600 MHz at 50 Ohm with VSWR <2.0, and sealing the whole build to IP67 behind an integrated N-male connector, it gives planners a footprint they can predict before the site survey. The 600 mm radome at 20 mm diameter and 0.23 kg weight keeps installation a one-person job, while 100 W handling, DC grounding, ≈77% efficiency and a −45 °C to +85 °C range state its limits up front. For any 1.5 GHz outdoor deployment that needs one slim antenna to serve everything in sight, this antenna is the practical choice.